Where is the transmission drain plug on a Harley?

The drain plus is located between the shock absorbers, underneath the transmission. Use the ratchet, 3-inch extension and 5/8-inch socket to remove it. Once it's loose, finish removing the drain plug by hand to prevent it from falling into the drain pan.

.

In respect to this, where is the drain plug on a Harley Davidson?

On Softails, the drain plug is found between the rear shocks; Dyna and Touring models have drain plugs under the left side of the engine's oil pan. Replace the drain plug's O-ring, then screw it into place after the oil has drained.

Similarly, how often should I change the transmission oil in my Harley? The owner's manual tells you to change your engine oil every 5K miles, primary every 10K and transmission every 20K. Since you're changing your engine oil at 3K miles, you should change the primary every 6K and the transmission every 12K.

Then, how do you check transmission fluid on a Harley?

How to Check the Transmission Fluid in a Harley

1. Run the engine until it is warm, shifting through all the gears.
2. Loosen the transmission dipstick by unscrewing it, but do not remove it.
3. Straddle your Harley and hold it level, off the side stand, for 20 to 30 seconds.
4. Withdraw the dipstick and read the amount of fluid in the transmission.

What kind of fluid goes in a Harley primary?

You actually have a couple of choices for the primary drive. The optimum product would be Mobil 1 Racing™ 4T 10W-40 motorcycle oil, but it is also okay to use Mobil 1™ V-Twin 20W-50.

Related Question Answers

How many quarts does a Harley 103 take?

According to numerous specs listed on the web, the SE 103 oil capacity is 4 qts. Same as Twin Cam 88 motor.

How many quarts of oil does a Harley Davidson take?

Book calls for 4 quarts but Put in 3.5 quarts with filter change and then run bike until it gets hot and recheck. Because the oil is Synthetic is will not expand. If you run bike at highway speeds and oil starts coming out of the air cleaner, you've put too much in the engine.

Who makes Harley oil?

AMSOIL INC. has 30 years of experience providing superior lubricating protection for all brands of motorcycles, and AMSOIL Synthetic Motorcycle Oils have been tested in millions of over-the-road miles. Testimonials from countless motorcyclists further demonstrate the superiority of AMSOIL Synthetic Motorcycle Oils.

What oil should I use in my Harley transmission?

Amsoil recommends their 75W-110 gear lube for Harley big twin transmissions. It's probably way overkill unless you like extended drain intervals. This is not true. The first recommendation from Amsoil is 20w-50 Engine oil, the same as Harley..Then it's 75w-110 and 75w-90.

How do you check automatic transmission fluid?

To check your automatic transmission fluid, follow these steps:

1. Pull out the dipstick. With the gearshift in Neutral or Park and the parking brake on, let your engine run.
2. Check the fluid.
3. Wipe the dipstick with a clean, lint-free rag; then reinsert it and pull it out again.

How much is a transmission fluid for a Harley Davidson?

Q: How much fluid goes in my transmission? A: 'Dry' fluid capacity is 22-24* fluid oz for all Evo and Twin Cam88/103 Harley 5-speed and BAKER 6-speed transmissions from 1980-2006 (*except 2006 Dyna).

Do you check Harley oil hot or cold?

On any of the Harley models(except V-rod) you always check the oil level on the Jiffy stand(aka kick stand), and yes I said it folks Jiffy stand. Whether your bike is hot or cold doesn't matter because on the dipstick there are two readings, one level being the cold level which will be lower than the hot reading.

What is a jiffy stand on a motorcycle?

The jiffy stand is Harley-Davidson's name for the item that permits a motorcycle to be parked leaning to the left side but with no risk of falling over.

Do you check Harley oil on kickstand?

The transmission oil is checked with the motorcycle on a level surface and on the kick stand. Checking oil on Harley is similar however there is the option to check the oil level on the kickstand or with the vehicle upright. Again, start with the motorcycle already warm. Remove the dipstick/fill plug and wipe it off.

How many quarts does a Harley hold?

Book calls for 4 quarts but Put in 3.5 quarts with filter change and then run bike until it gets hot and recheck.

What is the primary on a Harley Davidson?

The primary drive on this motorcycle is a very wide Kevlar/rubber belt. The large chain is the final drive. All the engine's power ends up going to the back wheel. The engine's power ends up going to this extremely wide back wheel.