Where is the flasher relay on a 2001 Jeep Cherokee?

Start with the Flasher Relay. It will be a small black 5-pronged relay located under the headlight switch. To access, you will need to remove the panel below the steering column, (3 screws), then the metal plate behind that panel (2 screws).

.

Also know, how do you change the flasher relay on a Jeep Cherokee?

How to Replace Your Turn Signal Relay in a Jeep Grand Cherokee

1. Check the turn signals by turning on the hazard lights and walking around your Jeep Grand Cherokee, seeing if each corner light blinks.
2. Locate the fuse box on the driver's side underneath the dash.
3. Remove the lower dash panel and use a flashlight to locate the flasher unit.
4. Replace the bad flasher with the new one.

Similarly, how do I fix my blinker? In fact, it's one of the easiest repairs you'll ever do.

1. Locate your relay cluster. You can find this in your car's owner's manual.
2. Locate the turn signal relay. This should also be in your owner's manual.
3. Once you can see your relays, remove the old turn signal flasher relay and replace it with the new one.

Besides, where is the flasher relay located on a 2004 Jeep Grand Cherokee?

The relay is located to the left of the steering wheel, under the dashboard. You will need to remove two of the dashboard covers to get to it. The first one is right above the steering wheel, and you should be able to pop it off by just pulling up on it as shown in Figure 2.

Why are my hazard lights not working?

Turn signals only work when the ignition is on; hazard lights work whether the ignition is on or not. The two systems have separate power supplies, so they have separate fuses. You may have a blown fuse. The fault could be a fuse, turn signal switch, hazard switch, flasher unit, or a broken wire or connection.

Related Question Answers

How much is a turn signal flasher?

The average cost for a signal flasher replacement is between $105 and $116. Labor costs are estimated between $36 and $47 while parts are priced at $69.